A Review Of alliant rl-26

A Review Of alliant rl-26

Blog Article

As for all other powders, both have an issue with them not being able to continue to be under Performing pressures at more than 1300fps because they've got a a lot quicker melt away level that St marks 296, or burn up so scorching that They only burn up the hulls quickly isntead.



Have shot in -twenty currently. Each time a fantastic stiff breeze comes out of your north, one person often claims "It's a dry chilly".

I use 296 and acquire terrific factory on the lookout shells. In case you are applying Winchester HS hulls make sure you are employing the right data as well as the HS wad as its distinctive within the old compression hull data. And has been previously advised, weigh your shot cost as many of them are gentle. You need each little bit of shot you can find in that hull. You may need to open it up so it really is dropping a consistent 225 grains of shot.

Dano523 stated: Only difficulty with not reaming the shot bushing to toss 226 of shot inside a HS hull with .296" powder bushing, would be the shot will almost certainly rattle while in the shell (my Edition of a apply only load In the event the shot rattles any time you shake the round). Click to broaden...

Guaranteed really need to concur with this dialog which the new 410 powders just aren't an improved propellant. I have tried these newer ones also and 296 is still the way to GO!

And Indeed, I have employed all three powders, and could drop flats of them on stations in mixes, and you also wouldn't have the ability to tell which shell experienced what powder, since the speeds and patterns are so close alongside one another on the 1350fps assortment, there isn't a feasible difference in performance in the shells.




So 296/297 at 1200fps leaves a great deal of unburnt powder while in the bore, when the more quickly/higher Operating strain loads precise winds up with a lot less unburnt powder within the bores isntead.

all powder will burn up hulls but with these three I might get 6 to ten reloads with no a dilemma. According to the hull option There exists enough analyzed load data on This website for these powders. Your Domain Name Just search it out you won't be dissatisfied.

Powder would seem a tad dirty and maybe burns up the hulls somewhat more rapidly, I do think (nevertheless very easily get 5 reloads with out an excessive amount of close inspection and sorting-some past extended but have to have near search after a few reloads). I’m conservative within the reloads and dispose earlier than a lot of do I feel. Crimps are great in 99% from the hulls even by way of quite a few reloads. Overall I like it ample to maintain working with it.

0   Reply This can be an older thread, you might not receive a response, and will be reviving an old thread. Please contemplate creating a new thread.

Alliant Powder’s new 410 flake powder is the only real flake powder notably personalized to the stringent needs of.

Thanks to its Fantastic ballistic functionality, the 410 generates patterns without flaws. With its dependable general performance less than any and all climatic circumstances, shot right after shot and good deal following great deal, the new 410 will promptly turn out to be your most well-liked choice for reloading powder.




This is an more mature thread, you may not receive a response, and could be reviving an old thread. Remember to consider developing a new thread.

The shell are definetly underneath powered. Once again I'm using Alliant Green Dot powder as proposed from other forums which i read through. I am open up to any suggestions or have a peek at this web-site suggestions on these loads.